An improvement over a standard PA104 Bubble Etch tank. This unit is the same as the Bubble Etch Tank with the addition of an integral spray wash tank. The spray wash is solenoid operated and all electrical controls are on the front panel. Connections are provided at the rear for drain and cold water requirements. The integral spray wash tank offers safer and more efficient etching of boards than a standard bubble etch tank and being wider also gives greater stability.
The temperature is set by adjusting the variable thermostat control knob. (Optimum temperature for Ferric Chloride is 40 – 45 Deg C)
Complete with an IEC socket and supplied with 2 metres mains cable with moulded 13amp plug and a syphon. Instructions included.
Dimensions: Width 275mm,depth 525mm,height 380mm
Heater: 500W
Tank capacity: 5 litres
Voltage: 230V
